Friday 24 November 2017

The Carbon Intensity of UK Grid Electricity




What it Means for Low Carbon Buildings


Take a look at this chart. It's nothing short of astonishing. Up to 2012 the amount of carbon dioxide emissions associated with the delivery of one unit (kilowatt hour, or kWh) of electricity in the UK was hovering around 500gCO2/kWh. Since then, the amount of carbon dioxide that is emitted for each unit of electricity has plummeted. In 2016 the average was 269gCO2/kWh, a fall of nearly half in only four years. This change has far-reaching implications for regulators, not least those involved in ensuring the low carbon transition of the UK building stock, both newly constructed buildings and the improvement of the existing stock.

So what's behind the fall?




The first factor is the retreat of coal-fired power stations. In 2012, the government's Digest of UK Energy Statistics (DUKES) has coal fired power stations producing 44% of our electricity nuclear plants were suffering from outages and gas prices had risen, so coal use was at a high. By 2016 the corresponding figure for coal was only 9%. In the same period, gas fired power stations rose from 24% to 42% of UK power generation. This matters for two reasons. First of all, because coal is made up of long-chain hydrocarbons, with a higher ratio of carbon atoms to hydrogen atoms it produces about 60% more carbon dioxide than natural gas for each unit of heat energy produced in burning. Second, gas is more often burnt in a Combined Cycle Gas Turbine (CCGT) power plants with conversion efficiencies of up to 60%, compared to 40% for conventional steam turbines.



The second factor is the increasing contribution from renewables in the electricity supply. Enormous amounts of wind energy, biofuel fired generation and solar energy have come online. In 2012 renewables and 'other' represented 11% of UK electricity supply. In 2016, this had risen to 27.8%.

As a result the average carbon intensity of electricity in 2016 at 269 gCO2/kWh was only just higher than that for gas (216 gCO2/kWh). When you add in an efficiency for a gas boiler at (say) 80%, the gap disappears.

This is huge.

For years electricity has been the bad boy in low carbon building design. People fretted as a series of reports from the Energy Savings Trust showed that heat pump installations in the UK were operating nowhere near their advertised efficiencies and were consequently underperforming gas boilers for carbon emissions. Simple resistive electrical heating by panel heaters or immersion heaters for hot water were to be avoided at all costs.

Four short years later and all this is is turned on its head.

And we're only just getting started with renewables. In September, Dong Energy announced that it would move forward with the world's largest offshore wind farm, Hornsea 2 off the Yorkshire coast, with development costs that had fallen by half compared to previous offshore farms. A couple of week later, and not to be outdone, the UK's first subsidy-free solar farm was announced. It's still a bit of an outlier combining solar with battery energy storage and using pre-existing grid connections from with an earlier development, but it's a clear sign of the direction of travel. The carbon intensity of grid electricity is heading only in one direction.

But there's another wrinkle to consider. The carbon intensity of the grid is not a static value. It varies constantly as the mix of generators fluctuate to meet different levels of electricity demand and in response to changes in wind and sunlight. On 11th June this year, it was windy and sunny at the same time. Records tumbled. The carbon intensity of grid electricity in the middle of the day on was below 80gCO2/kWh.





So now the moment when you choose to take power from the grid is a strong determinant of the actual instantaneous carbon emissions your electricity use is creating.

Some uses of electricity - for example for preparing domestic hot water, or to some extent space heating buildings could be relatively time independent.  If I'd known ahead of time that carbon emissions would be so low on 11th July, I'd have been able to set a timer for my immersion heater to heat water for me at midday and got my tank of hot water at fully one third of the carbon emissions of using gas heating.

And the technology to do this is just around the corner.  This awesome new grid carbon intensity forcasting service has been recently launched by the National Grid the Met Office and WWF, with an API that software developers could use to do just this kind of thing.

 

So where does this leave low carbon building?


The current building regulations in England and Wales were last reviewed in 2012 and set minimum carbon emissions rates that developers must design to. The carbon intensity of electricity in the approved calculation (the Standard Assessment Procedure or SAP) is currently 519gCO2/kWh, which was accurate at the time. Now it is woefully behind the curve.

Buildings are normally intended to be long-lasting. If we allow ourselves to imagine a future where digital technologies, the smart distribution of electricity, demand response, energy storage and renewables combine in a so-called 'Smart Grid' then a number of significant observations about low carbon building emerge:

  • Even based on the current carbon intensity, never mind the future direction of travel over the life of a building, it is utterly beyond me that any new build or significant refurbishment should include gas heating.

  • The current enthusiasm among UK policy makers and local authorities for district heating (for example this recent consultation by Scottish government) could also be a troubling dead end. District heating itself is neither intrinsically clean nor green - it all depends what heat source you put at the other end of the pipes you're going to dig up all the streets to install. Gas fired combined heat and power may be seen as low carbon at the moment, but how long will it look so appealing if electricity continues on its current path?

  • Building codes are currently focused on regulating carbon emissions. In a world of low carbon electricity you can meet a carbon target with a draughty garden shed full of electric fan heaters. It's time to move to energy targets (kWh/m2) to create buildings that sip energy and liberate power for the demands created by the electrification of transportation.

If I was building my own Grand Design right now, my future-proof forever home based on these observations here's what I'd go for:

  • High levels of insulation and air tightness to drive down space heating demand to a practical minimum

  • Eliminate the wet heating system - I'd go underfloor electric coupled to a high thermal mass floor to allow price and carbon responsive electricity purchase to heat the slab at times of excess renewable generation

  • Direct electric hot water cylinder - again allowing price-responsive purchase of electricity as well as diversion of excess generation from...

  • the inevitable....beautiful solar panels on the roof - as many as possible!

Could this be the future direction energy efficient buildings? What do you think?